Energysaver; Acoustic Signals - Electrolux ESL 6601RA Benutzerinformation

How to activate the Multitab option
1. Press the on/off button to activate the
appliance.
2. Press the Multitab touchpad, the re-
lated indicator comes on.
The option stays on until you deactivate it.
Press the Multitab touchpad, the related
indicator goes off.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Deactivate the Multitab option.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse
aid.

5.4 EnergySaver

This option decreases the temperature in
the last rinse phase and the duration of
the drying phase.
The use of this option decreases the ener-
gy consumption (up to 25%) and the pro-
gramme duration.
The dishes can be wet at the end of the
programme.
How to activate the EnergySaver
option
1. Press the EnergySaver touchpad.
• If the option is applicable to the pro-
gramme, the related indicator
comes on. In the display you can
see the update of the programme
duration.
• If the option is not applicable to the
programme, the related indicator
flashes quickly 3 times and then
goes of.

5.5 Acoustic signals

The acoustic signals operate when the
appliance has a malfunction or when the
adjustment of the level of the water soft-
ener occurs. It is not possible to deacti-
vate these acoustic signals.
There is also an acoustic signal that oper-
ates when the programme is completed.
By default, this acoustic signal is off but it
is possible to activate it.
How to activate the acoustic signal
for the end of programme
1. Press the on/off button to activate the
appliance.
2. Make sure that the display shows the
programme P1. If the display shows a
different programme, press and hold
touchpads (4) and (5) until P1 shows
in the display.
3. Press and hold touchpads (4) and (5)
at the same time until the indicators of
touchpads (3), (4), (5) and (6) start to
flash.
4. Press touchpad (5),
• The indicators of touchpads (3), (4)
and (6) go off.
• The indicator of touchpad (5) contin-
ues to flash.
• The display shows the current set-
ting.
Acoustic signal on
Acoustic signal off
5. Press touchpad (5) to change the set-
ting.
6. Deactivate the appliance to confirm
the setting.
5.6 How to set the colour of the
TimeBeam
It is possible to change the colour of the
TimeBeam to match the colour of the
kitchen floor. There are 9 different colours
available.
It is also possible to deactivate the Time-
Beam.
1. Press the on/off button to activate the
appliance.
2. Make sure that the display shows the
programme P1. If the display shows a
different programme, press and hold
touchpads (4) and (5) until P1 shows
in the display.
3. Press and hold touchpads (4) and (5)
at the same time until the indicators of
ENGLISH 27