Setting And Starting A Programme - Electrolux ESL 4300RA Benutzerinformation

10 www.electrolux.com
3. Load the baskets.
4. Add the detergent.
• If you use the combi detergent tab-
lets, activate the Multitab option.
7.1 Using the detergent
A
7.2 Setting and starting a
programme
The Auto Off function
To decrease the energy consumption, this
function automatically deactivates the ap-
pliance a few minutes after:
• You have not closed the door to start
the programme.
• The programme is completed.
Reset function
For some settings it is necessary that the
appliance is in user mode.
To set the appliance in user mode, do the
Reset function.
1. Press and hold, at the same time,
of
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
3. Press the button of the programme
you want to set. The related pro-
gramme indicator comes on.
4. Close the appliance door. The pro-
gramme starts.
B
30 A
20
+ -
C
and until the indicator
comes on.
5. Set and start the correct programme
for the type of load and the degree of
soil.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
Starting a programme with delay
start
1. Set the programme.
2. Press Delay again and again until the
indicator of the number of hours you
want to set comes on (3 or 6).
• The Delay indicator comes on.
3. Close the appliance door. The count-
down starts.
• When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while
the countdown operates
Do the Reset function.
When you cancel the delay start,
you have to set the programme
again.
Cancelling the programme
Do the Reset function.