How To Activate The Rinse Aid Dispenser - Electrolux ESL 4300RA Benutzerinformation

14 www.electrolux.com
Problem
The appliance does not drain the
water.
The anti-flood device is on.
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes appear, contact the
Service.
10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on
glasses and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector
to a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature drying
phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tab-
lets can be the cause. Try a different
brand or activate the rinse aid dispens-
Possible solution
Make sure that the pressure of the water sup-
ply is not too low. For this information, con-
tact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not
clogged.
Make sure that the inlet hose has no kinks or
bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or
bends.
Close the water tap and contact the Service.
er and use rinse aid together with the
combi detergent tablets.
Refer to 'HINTS AND TIPS' for
other possible causes.
10.2 How to activate the rinse
aid dispenser
The activation of the rinse aid dispenser
can occur only with the Multitab option
activated.
1. Press the on/off button to activate the
appliance.
2. Do the Reset function.
3. Press and hold, at the same time,
of
flash.
4. Press
•
The indicators of
off.
• The indicator of
to flash.
• The end indicator is off.
5. Press
comes on. The rinse aid dispenser is
activated.
6. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
7. Adjust the released quantity of rinse
aid.
and until the indicators
, and
.
and
continues
. The end indicator
start to
go