Setting The Water Softener - Electrolux ESF 2410 Benutzerinformation

1. Make a check if the water softener level
is correct for the water hardness in your
area. If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dish-
washer.
5. Set the correct washing programme for
the type of load and soil.

Setting the water softener

The water softener removes minerals and
salts from the water supply. Minerals and
salts can have bad effect on the operation of
the appliance.
Water hardness is measured in equivalent
scales:
• German degrees (dH°).
°dH
>24
22- 24
20- 22
18- 20
16- 18
13- 16
10- 13
7- 10
4- 7
< 4
1) No use of salt required.
Electronic adjustment
The water softener is set at the factory
at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold the programme selection/
cancel button.
4. Release the programme selection/cancel
button when programme indicator light A
starts to flash and programme indicator
light B comes on.
5. Wait until programme indicator light B
goes off.
– Programme indicator light A starts to
flash.
– The end indicator light starts to flash.
Water hardness
mmol/l
>4.2
3,9- 4,2 39- 40
3,5- 3,9 35- 39
3,2- 3,5 32- 35
2,8- 3,2 28- 32
2,3- 2,8 23- 28
1,8- 2,3 18- 23
1,2- 1,8 12- 18
0.7- 1,2
< 0.7
6. Fill the detergent dispenser with the cor-
rect quantity of detergent.
7. Start the washing programme.
If you use detergent tablets, refer to the
chapter 'Use of detergent'.
• French degrees (°TH).
• mmol/l (millimol per litre - international unit
for the hardness of water).
• Clarke.
Adjust the water softener to the water hard-
ness in your area. If necessary, contact your
local water authority.
°TH Clarke
>40 > 29
27- 29
25- 27
23- 25
20- 23
17-20
13- 17
9- 13
7- 12 5- 9
< 7
6. Press the programme selection/cancel
button one time.
– Programme indicator light A starts to
flash.
– The setting function of the water soft-
ener is activated.
– The end indicator light flashes to show
the level of the water softener.
Example: 5 flashes, pause, 5 flashes,
pause, etc... = level 5.
7. Press the programme selection/cancel
button one time to increase the water
softener level by one step.
8. Press the on/off button to save the oper-
ation.
electrolux 21
Water hardness
setting
< 5
10
9
8
7
6
5
4
3
2
1)
1