Husqvarna 543 RBX Bedienungsanweisung Seite 25

• Slide the drive shaft back into the sleeve. Make sure
the shaft engages correctly by turning it and pushing
at the same time.
• When the shaft is correctly installed in the sleeve, the
end of the shaft should project about 10 mm beyond
the edge of the sleeve.
• Install the drive shaft sleeve in the clutch cover so that
the hole is positioned directly underneath the locking
button on the clutch cover.
• Make sure the shaft engages correctly by turning it
and pushing at the same time.
MAINTENANCE
–
English 25