Preparation; Installing The Filters; Inserting Batteries In The Remote Control - Sharp FU-21SE Bedienungsanleitung

PREPARATION

INSTALLING THE FILTERS

To maintain the quality of the filters, they are installed in the main unit within polyvinyl bags.
Be sure to remove the filters from the polyvinyl bags before using the unit.
1
Remove the filters
1
Place the unit facing up and
remove the front panel
Bring up both sides of the front panel bottom
to remove the front panel.
2
Remove the filter
support
Two tabs are pinched, and it
is lifted to remove it.
3
Remove the deodorization
filter (gray) and HEPA filter
(white) that are inside the
polyethylene bags.

INSERTING BATTERIES IN THE REMOTE CONTROL

Be sure to remove the power plug from the wall outlet.
Filter support
Deodorization filter
1
Remove the
back cover
Press and slide the
back cover to re-
move.
2
Insert batteries
Insert batteries with
and as shown
below.
3
Close the back
cover
E-6
Front panel
Tabs
Tab(2 places)
HEPA filter
About the batteries
• The battery life is about 1 year.
Replace the batteries when the remote con-
trol becomes inoperative.
• Incorrect usage of the batteries may cause
battery fluid leakage and/or damage. Take
caution of the following when handling:
• When replacing the batteries, replace
both batteries with new ones of the same
type. (Use AA alkaline batteries (2 units)
or AA manganese batteries (2 units).)
• When not using the unit or remote con-
trol for an extensive period, remove the
batteries. This prevents malfunction of the
remote control from battery fluid leakage.
* The included batteries are for initial use only
and may deplete before 1 year.