Scheppach SG5200D Originalbetriebsanleitung Seite 35

10.2.5 Servicing the battery (8)
CAUTION
Batteries contain sulphuric acid, which can cause
severe chemical burns.
Avoid contact with skin, eyes or clothing at all
costs.
Wear safety goggles.
In case of contact:
– Skin contact: Rinse thoroughly with plenty of water
immediately.
– Eye contact: Rinse eyes with plenty of water for at
least 15 minutes and seek medical attention imme-
diately.
– Swallowing: Drink plenty of water or milk and seek
medical attention immediately.
Notes:
Protect the electronic components by avoiding jump start-
ing – this can cause serious damage to the electronics
and electrical systems. Instead, charge the battery prop-
erly.
To avoid damage to the electronic components and elec-
trical systems, please do not use jumper cables to start
the engine. Such interventions can damage sensitive con-
trol units or sensors.
If the use of jumper cables is unavoidable, please note
the following:
• Only use high-quality jumper cables with a large
cross-section that are rated for at least 400 amps.
• Read all instructions carefully and check the accom-
panying illustrations before starting the procedure.
Damage can only be reliably avoided by following the cor-
rect procedure.
11 Storage and transport
WARNING
Danger of injury and burning!
The product can start unexpectedly and cause injuries.
– Switch off the engine before carrying out any clean-
ing or maintenance work.
– Allow the engine to cool down.
• Empty the product completely.
• Clean and check the product for damage.
11.1 Storage
ATTENTION
Risk of damage!
If the product is not stored properly, the engine can be
damaged.
– Store the product protected against dirt, dust and
moisture.
DANGER
Risk of fire and explosion!
Storing the product near potential sources of ignition
can result in a fire or an explosion. This can lead to se-
vere burns or death.
– Eliminate possible sources of ignition, such as fur-
naces, hot water boilers with gas, gas dryers, etc.
Tool required:
• Open-ended spanner, size 10/12 mm (13)
• Collection bucket*
• Fuel extraction pump*
• Battery charger*
* = may not be included in the scope of delivery!
11.1.1
WARNING
Do not remove the fuel in enclosed spaces, near fire or
when smoking. Petrol fumes can cause explosions and
fire.
1. Empty the fuel tank using a petrol extraction pump.
2. Start the engine and let it run until the remaining fuel
is used up.
3. Store fuel in tanks specifically designed for this pur-
pose.
4. Change the oil at the end of every season.
5. Open the maintenance door (4).
6. Set the mechanical ON/OFF switch (15) to the correct
position (STOP).
7. Remove the ignition key (3b) from the ignition lock
(3a) and store it securely to prevent unauthorised or
improper use by children and other people.
8. Remove the battery (8) and store it fully charged in a
dry and locked room.
9. Store the product in a well-ventilated place or area.
11.1.2
In case of storage over a longer period of time, the fuel
must be drained.
1. Hold a collection bucket under the hose on the fuel
extraction pump.
2. Open the tank cover (1) by turning it anti-clockwise.
3. Remove the fuel filter insert (1a).
4. Push the hose of the petrol extraction pump into the
fuel tank and drain out the of the petrol extraction
pump completely using the petrol extraction pump.
5. Reinsert the fuel filter insert (1a).
6. Seal the tank cover (1) again by placing it straight on
and turning it clockwise.
www.scheppach.com
Preparing for storage (Fig. 7-9)
Drain fuel with a fuel extraction pump
(Fig. 12)
GB | 35