Scheppach TRW210 Originalbetriebsanleitung Seite 9

Table of contents
1 Introduction ........................................................
2 Proper use..........................................................
3 Product description (Fig. 1) ................................
4 Scope of delivery (Fig. 1) ...................................
5 Unpacking ..........................................................
6 Technical data....................................................
7 Safety instructions..............................................
8 Operation ...........................................................
9 Cleaning and maintenance ................................
10 Storage and transport ........................................
11 Repair and ordering spare parts ........................
12 Disposal and recycling .......................................
Explanation of the symbols on the
product
Symbols are used in this manual to draw your attention to
potential hazards. The safety symbols and the accompa-
nying explanations must be fully understood. The warn-
ings themselves will not rectify a hazard and cannot re-
place proper accident prevention measures.
Before commissioning, read and observe
the operating manual and safety instruc-
tions!
Explanation of the signal words in
the operating manual
DANGER
Signal word to indicate an imminently haz-
ardous situation which, if not avoided, will re-
sult in death or serious injury.
WARNING
Signal word to indicate a potentially hazard-
ous situation which, if not avoided, could re-
sult in death or serious injury.
CAUTION
Signal word to indicate a potentially hazard-
ous situation which, if not avoided, could re-
sult in minor or moderate injury.
ATTENTION
Signal word to indicate a potentially hazard-
ous situation which, if not avoided, could re-
sult in product or property damage.
1 Introduction
9 Manufacturer:
9 Scheppach GmbH
10 Günzburger Straße 69
10 D-89335 Ichenhausen
10 Note:
10 In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability for
10
damage to the product or caused by the product arising
10
from:
11
• Improper handling
11
• Non-compliance with the operating manual
11
• Repairs carried out by third parties, unauthorised spe-
cialists
11
• Installing and replacing non-original spare parts
• Improper use
Note:
The operating manual is part of the product and contain
important information for safe, proper and economical op-
eration. Please also observe the applicable national regu-
lations. Read all operating and safety instructions careful-
ly before use and only use the product as described.
Keep the manual and pass it on when you give the prod-
uct to someone else.
2 Proper use
The product is only suitable for tightening screws and
nuts to a preset force of 40-210Nm. Never use the prod-
uct to loosen screw connections.
The maximum permissible measurement inaccuracy of
the device is +/-4% – in accordance with EN ISO
6789-1:2017 – of the respective set value. Each torque
wrench is supplied with a calibration certificate, which
shows the measuring accuracy of your wrench.
The product may only be used in the intended manner.
Any use beyond this is improper. The user, not the manu-
facturer, is responsible for damages or injuries of any type
resulting from this.
An element of the intended use is also the observance of
the safety instructions, as well as the assembly instruc-
tions and operating information in the operating manual.
Persons who operate and maintain the product must be
familiar with the manual and must be informed about po-
tential dangers.
The liability of the manufacturer and resulting damages
are excluded in the event of modifications of the product.
The product may only be operated with original parts and
original accessories from the manufacturer.
The safety, operating and maintenance specifications of
the manufacturer, as well as the dimensions specified in
the technical data, must be observed.
Please note that our products were not designed with the
intention of use for commercial or industrial purposes. We
assume no guarantee if the product is used in commercial
or industrial applications, or for equivalent work.
www.scheppach.com GB | 9