Scheppach DC500 Originalbetriebsanleitung Seite 19

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new device brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling
• Failure to comply with the operating instructions.
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failures of the electrical system due to failure to
observe the national electrical requirements and
regulations
Note:
The operating manual is part of the product and contain
important information for safe, proper and economical
operation. Please also observe the applicable national
regulations. Read all operating and safety instructions
carefully before use and only use the product as de-
scribed. Keep the manual and pass it on when you give
the product to someone else.
2. Device description
1. Retaining rod
2. Filter bag
3. Housing cpl. with engine
4. On/off switch
5a. Side panel right
5b. Side panel left
6. Suction hose
7. Wheel
8. Hose coupling
9. Floor plate
10. Dust bag
11. Clamp fitting
12. Adapter set
13. Intermediate plate
14. Hose clamp
15. Washer
16. Split pin
17. Fillister head screw M5x16
18. Fillister head screw M5x30
19. M5 hexagonal nut
20. Washer
21. toothed washer
3. Scope of delivery
• Housing cpl. with engine
• Floor plate
• Side panel right
• Side panel left
• Intermediate plate
• Suction hose
• Filter bag
• Dust bag
• Retaining rod
• Clamp fitting
• Wheel (2x)
• Hose coupling
• Adapter set (4-piece)
• Hose clamp (2x)
• Washer (2x)
• Split pin (2x)
• Fillister head screw M5x16 (12x)
• Fillister head screw M5x30 (4x)
• M5 hexagonal nut (4x)
• Washer
• toothed washer
• Operating manual
4. Proper use
The machine complies with the applicable EC ma-
chinery directive.
• The machine has been built according to the state-
of-the-art and the technical safety requirements.
Nevertheless, its use may cause danger to the life
and limb of the user or third parties, or damage to
the machine and other material assets.
• Only use the machine when in a technically faultless
condition, appropriately and in compliance with the
operating manual and with full knowledge of safety
and hazards! In particular, rectify malfunctions that
could impair safety immediately (or commission rec-
tification works accordingly)!
www.scheppach.com GB | 19