Scheppach FBCC12TPDF Originalbetriebsanleitung Seite 32

4. Open the oil filling opening (18).
5. Open the oil drain screw (19) and carefully allow
the oil to run into the container.
6. Reinsert the oil drain screw (19) with seal and
tighten securely.
7. Top up with new hydraulic oil. (contents: see
technical data) and check the oil level with the oil
dipstick. After an oil change, actuate the splitting
blade (4) several times without actually splitting.
Attention! Do not allow any dirt particles to enter
the oil container.
Dispose of the used oil properly at a local used
oil collection point. Dumping used oil in the soil
or mixing it with waste is prohibited.
We recommend oil from the HLP 32 range.
14.2 Changing the gearbox oil (fig. 19)
The gearbox is filled with SAE90 gear oil at the fac-
tory.
Drain the gear oil after the first 50 operating hours
and replace it with new oil as specified. The next oil
change should then be carried out every 250 operat-
ing hours or every six months, whichever comes first.
1. Disassemble the cardan shaft protective cover
(7) and set a sufficiently large container under the
gearbox.
2. First open the oil drain screw (gearbox) (21) and
then the oil filler plug (20) and drain the oil com-
pletely.
3. Close the oil drain screw (gearbox) (19) with a new
seal and fill new SAE90 gear oil into the opening
of the oil filler plug (20) using a funnel until the
lower edge of the oil sight glass (22) is almost cov-
ered with oil.
Check the oil level every 8 working hours. The oil lev-
el is correct when the lower edge of the oil sight glass
(22) is almost covered with oil.
Hydraulic system
The hydraulic system is a closed system with an oil
tank, oil pump and control valve.
The factory-completed system must not be changed
or tampered with.
Check the oil level regularly.
If the oil level is too low, the oil pump will be damaged.
Check hydraulic connections and screw connections
regularly for leaks - retighten if necessary.
Please provide the following information in the
event of any enquiries:
• Machine data - type plate
32 | GB
Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: Riving knife / riving spar guides, hy-
draulic oil, gear oil
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from
our service centre. To do this, scan the QR code on
the cover page.
15. Disposal and recycling
Notes for packaging
The packaging materials are
recyclable. Please dispose of
packaging in an environmen-
tally friendly manner.
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the product, the fuel tank and
the motor oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in an
environmentally friendly manner.