Introduction; Product Description (Fig. 1 - 19); Scope Of Delivery (Fig. 2) - Scheppach Fbcc12Tpdf Originalbetriebsanleitung

1. Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoy-
ment and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this product assumes no
liability for damage to the product or caused by the
product arising from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE 0113 not being observed
Note:
The operating manual is part of this product. It in-
cludes important instructions for the safe, proper
and economic operation of the product, for avoiding
danger, for minimising repair costs and downtimes
and for increasing the reliability and extending the
service life of the product. In addition to the safety
instructions in this operating manual, you must also
observe the regulations applicable to the operation of
the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of
application. Keep the operating manual in a good
place and hand over all documents when passing the
product on to third parties.

2. Product description (fig. 1 - 19)

1. Cylinder
1a. Locking pin with split pin
2. Operating lever a
3. Return bow
4. Splitting blade
4a. Support
5. Additional transport wheel
5a. Locking bolt, locking pin and spring split pins
5b. Locking bolt and locking pin
6. Trunk lifter
6a. Chain
6b. M16 x 90 mm bolt with hex nut
7. Cardan shaft protective cap
26 | GB
7a. Collar nut M10
8. M22 three-point bolts with hex nut
9. Transport wheels
9a. Wheel axle
9b. Safety splint
9c. Washer
10. Retainer arm
10a. M10 x 35 mm bolt with washer and hex nut
11. Operating lever b
12. Retainer hook
12a. M10 x 30 mm bolt with collar nut
13. Operating manual
14. Claw
15. Dust cover
16. Upper mounting arm
16a. Hanger pin
16b. PTO shaft (metre log splitter)
16c. PTO shaft (drive)
17. Lower mounting arm
17a. Connecting pin
18. Oil filling opening
19. Oil drain screw
20. Oil filler plug
21. Oil drain screw (gearbox)
22. Oil-level window

3. Scope of delivery (fig. 2)

Item Quantity Designation
1 a 2x Locking pin with split pin
4 a 1x Support
5 1x Additional transport wheel
5 a 2x Spring split pin
5b 1x Locking bolt and locking
pin
6 1x Trunk lifter
6 a 1x Chain
6b 1x M16 x 90 mm bolt with
hex nut
7 1x Cardan shaft protective
cap
7 a 1x Collar nut M10
8 2x M22 three-point bolts with
hex nut
9 2x Transport wheels
9 a 1x Wheel axle
9b 2x Safety splint
9c 4x Washer
10 1x Retainer arm
10 a 1x M10 x 35 mm bolt with
washers and hex nut
12 1x Retainer hook
12 a 2x M10 x 30 mm bolt with
collar nut
13 1x Operating manual