Technical Data; Unpacking; Assembly / Before Commissioning - Scheppach Mix200 Originalbetriebsanleitung

• Before performing setting or maintenance work, re-
lease the start button and pull out the mains plug.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety In-
structions" and the "Intended Use" together with the
operating manual as a whole are observed.
• Avoid accidental starting of the machine: the oper-
ating button may not be pressed when inserting the
plug in an outlet. Use the tool that is recommended
in this operating manual. This is how to ensure that
your machine provides optimum performance.
• Keep your hands away from the working area when
the machine is in operation.
Warning! This power tool generates an electromagnet-
ic field during operation. This field can impair active or
passive medical implants under certain circumstances.
In order to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the power tool.

6. Technical data

Engine
Engine output
Max. speed
Max. drum speed
Capacity
Protection category
Operating mode*
Protection class
Dimensions
Weight
Subject to technical changes!
*S6 30 %: Continuous duty with intermittent loading
(operating time 10 min.)
In order avoid impermissible overheating of the motor,
the motor should be driven for only 30% of the operat-
ing time with the stipulated nominal power and must
then continue to run with no load for the remaining 70%
of the operating time.
230 V~ / 50 Hz
0.85 kW
2800 rpm
29.5 rpm
200 l
IP45D
S6 30%
II
1260 x 850 x 1450 mm
56 kg
www.scheppach.com
Noise & vibration
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
Noise data
Sound power level L
WA
Sound pressure level L
pA
Uncertainty K
WA/pA
7.

Unpacking

Open the packaging and carefully remove the device.
Remove the packaging material, as well as the pack-
aging and transport safety devices (if present). Check
whether the scope of delivery is complete. Check the
device and accessory parts for transport damage. In
the event of complaints the carrier must be informed
immediately. Later claims will not be recognised.
If possible, keep the packaging until the expiry of the
warranty period. Familiarise yourself with the device by
means of the operating manual before using for the first
time. With accessories as well as wearing parts and
replacement parts use only original parts. Spare parts
can be obtained from your specialist dealer. When or-
dering please provide our article number as well as
type and year of manufacture for your device.
m ATTENTION!
The device and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!

8. Assembly / Before commissioning

m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
Fitting the three-point bolts (Enclosed accesso-
ries bag (A) Fig. 4
On rear foot with wheel axle (k), fit split pin, washer,
tyres (l), washer, split pin on both sides.
Slightly bend open the split pins after fitting.
Fitting the foot at the front with the frame (En-
closed accessory bag (B) Fig. 5
Connect the support foot into the frame and fix it with
two M8x70 hexagonal bolts. Connect the spring into
the fixture provided. Guide the actuating rod from be-
96.04 dB
76.04 dB
3 dB
GB | 23