15.2
Fold the upper push bar (4)
together (Fig. 1)
WARNING
Risk of jamming!
Always hold the push bar with one hand at the highest
point.
–
Never place fingers between the upper push bar
and the lower push bar.
For space-saving storage, the upper push bar (4) is fold-
able.
1. Remove the grass collection basket (23).
2. Unhook the pull starter (25) from the cable hook (24).
3. Open the quick clamp levers (5) on the lower push bar
(8).
17 Troubleshooting
Fault
Product runs unsteadily and vibrates
heavily.
Engine does not run.
Engine runs unsteadily.
Lawn turns yellow, uneven mowing re-
sults.
The discharge of grass clippings is un-
clean.
18 Disposal and recycling
Notes for packaging
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
You can find out how to dispose of the disused
device from your local authority or city
administration.
Fuels and oils
• Before disposing of the product, the fuel tank and the
engine oil tank must be emptied!
• Fuel and engine oil do not belong in household waste
or drains, but must be collected or disposed of sepa-
rately!
4. Turn the quick clamp levers (5) at a right angle to the
5. Move the upper push bar (4) down. The cables must
16 Repair & ordering spare parts
16.1
Please provide the following information when ordering
spare parts:
• Model designation
• Item number
• Type plate data
Spare parts / accessories
Blade - Article no.:
Engine oil - Article no.:
Possible cause
Screws are loose.
Blade fasteners are loose.
Blade is unbalanced.
Engine brake lever not pressed. Press engine brake lever.
Throttle in wrong position.
Spark plug defective.
Fuel tank is empty.
Contaminated fuel.
Motor defective.
Air filter dirty.
Spark plug dirty.
Air filter dirty.
Spark plug dirty.
Cutting height is too low.
Blade is worn.
Grass collection basket blocked. Empty the grass collection basket or remove
• Empty oil and fuel tanks must be disposed of in an en-
www.scheppach.com
push bar. To do this, you must move the quick clamp
levers (5) away from the lower push bar (8) slightly.
not be pinched in the process.
Ordering spare parts
Remedy
Check screws.
Check blade fasteners.
Replace blade.
Check setting.
Replace spark plug.
Fill with fuel.
Empty the fuel tank and fill with clean fuel.
Contact authorised customer service.
Clean the air filter.
Clean the spark plug.
Clean the air filter.
Clean the spark plug.
Adjusting the cutting height
Replace blades.
the blockage.
vironmentally friendly manner.
7911200639
7850000025
GB | 37