Operation; Information On Sawing; Inserting And Removing The Battery; Switching On And Off - Parkside Phksa 20-Li C4 Originalbetriebsanleitung

Charging the battery
1. Remove the battery (29) from the device.
2. Push the battery (29) into the charging
slot of the battery charger (27).
3. Connect the battery charger (27) to a
power outlet.
4. After charging, disconnect the battery
charger (27) from the mains.
5. Pull the battery (29) out of the battery
charger (27).
Control LEDs on the charger
Meaning of the control indicators on the
charger (27):
green red
lights up —
— lights up
flashes flashes

Operation

Information on sawing

• The maximum speed stated on the tool
must not be exceeded. If indicated, the
speed range must be complied with.
• Maintenance work and modifications to
circular saw blades should only be per-
formed by a professional, i.e. a person
with specialist training and experience
who is familiar with the design require-
ments and the necessary safety steps.
Inserting and removing the
battery
WARNING! Risk of injury due to uninten-
tional start-up. Only insert the battery into
the device once the device is fully prepared
for use.
NOTICE! Risk of damage! An incorrect bat-
tery can damage the device and battery.
Inserting the battery
1. Push the battery (29) along the guide into
the battery holder (19).
You will hear the battery click into place.
Removing the battery
1. Press and hold the battery release (28) on
the battery (29).
Meaning
• Battery is fully
charged
• stand-by (No
battery inserted)
Battery is charging
Battery not recog-
nized
2. Pull the battery out of the battery holder
(19).

Switching on and off

Switching on
1. Insert the rechargeable battery (29) into
the device.
2. Press and hold the switch lock (1).
3. Press and hold the On/off switch (2).
4. Wait until the device has reached full
speed.
Switching off
1. To turn it off, release the on/off switch (2).
2. Do not pull the sawblade out of the cut
until it has come to a standstill.
3. Remove the rechargeable battery (29)
from the device if you are leaving the
device unattended or if you have finished
working.

Transport

Notes
• Turn off the device.
• Make sure that all moving parts have
come to a complete stop.
• Remove the battery (29) from the device.
• Ensure that the protective cover (17) com-
pletely covers the circular saw blade (16).
• Always carry the tool by the handle (3) or
use the storage case (12) provided.
Cleaning, maintenance and
storage
WARNING! Risk of injury due to unin-
tentional start-up. Protect yourself when
performing maintenance or cleaning work.
Switch off the device and remove the battery
(29).
You should have any repair and maintenance
work that is not described in these instruc-
tions carried out by our Service Centre. Only
use original replacement parts.

Cleaning

WARNING! Electric shock! Never spray
down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
GB CY
13