Battery Replacement Procedure - PowerWalker DC UVS Bedienungsanleitung

7.

Battery Replacement Procedure

The DC UPS is designed with an easy-access battery cover.
EN
STEP 1 Turn off power switch. Disconnect the DC UPS from power and any
connected devices. Remove the battery door on the front of the DC UPS by
pulling up the battery door.
STEP 2 Remove the battery from enclosure; remove the wire connections
from the battery.
STEP 3 Connect the new battery (black-to-black, red-to-red); place the battery
into the enclosure, and then put the wires next by the battery inside of the
closure as shown bellow.
WARNING: Connect the correct color wires carefully to the corresponding
terminals. The battery has two color-coded terminals (red = +, black = -) as
well as the two colors of the wires. Misconnect the two wires to wrong
terminals might cause battery explosion.
Page 12