Cut To Length; Log Is Lying On The Ground; Limbing - Parkside Paghs 20-Li C4 Bedienungsanleitung

Always switch off the motor of
the wood cutter before changing
between trees .
You will have better control over
the product if you saw using the
lower edge of the blade bar (chain in
pulling direction) .
The saw chain must not touch the
ground or any object while sawing
through the material or thereafter .
Ensure that the saw chain does not
get stuck while sawing . The log must
not break or splinter .
Please also observe the
precautionary measures to protect
against kickback (see the safety
information) .
For sawing work on hillsides, always
stand in the area above the log .
To keep total control while sawing
through, reduce the pressure at the
end of the cut without loosening
your grip on the handles of the wood
cutter . Make sure the saw chain does
not touch the ground After finishing
the cut, wait until the saw chain
comes to a stop before removing
it. Always switch off the motor of
the wood cutter before changing
between trees .
WARNING!
m
If the saw chain gets stuck, do not
u
attempt to pull out the product with
force . There is a risk of injury . Turn
the motor off and use a lever arm
or wedge to release the product .
˜ Cut to length
Cutting to length means sawing
felled tree trunks into small sections .
Ensure that you have secure footing
and balance your body weight evenly
on both feet . If possible, the trunk
should be protected and supported by
branches, logs or wedges .
20 GB/IE/NI/MT
Make sure that the saw chain does
not touch the ground when sawing .
Make sure you have good footing
and stand above the trunk on sloping
terrain . To keep total control while
sawing through, reduce the pressure
at the end of the cut without
loosening your grip on the handles
of the wood cutter. After finishing the
cut, wait until the saw chain comes
to a stop before removing it . Always
switch off the motor of the wood
cutter before changing between
trees .
˜ Log is lying on the ground
Saw through the log completely from
above and ensure at the end of the cut
not to contact the ground . If you can
turn the tree trunk, saw two-thirds of
the way through it . Then turn the trunk
around and saw the rest of the way
through from above .
˜ Limbing
Limbing is the designation for the
sawing off of branches and boughs from
a felled tree .
WARNING!
m
Many accidents occur during the
u
removal of branches . Never cut
tree limbs when you are standing
on the log . Keep the spring back
area in mind if branches are under
tension .
Do not remove support branches
until after the sawing off.
Branches under tension must be
sawed from below to above, in order
to prevent jamming of the chainsaw .
When working on thicker branches,
use the same technique as when you
are sawing up a felled trunk .