Charging The Battery Pack (See Fig. A); Attaching/Disconnecting The Battery Pack; To/From The Tool; Checking The Battery Charge Level - Parkside PKSA 20-Li A1 Originalbetriebsanleitung

■ Do not drop the chainsaw, knock it against ob-
structions and do not use the guide rail as a lever.
■ Use the chainsaw only for sawing wood.
■ When sawing a branch that is under tension, be
prepared for it to spring back. Once the tension
in the wooden fibres is released, the branch can
hit the operator and/or knock the chainsaw out
of his hands.
■ Be extremely careful when cutting brushwood
and young trees. The thin material can catch in
the saw chain and fly in your direction or knock
you off balance.
Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the tool before you remove
the battery pack from or connect the battery
pack to the charger.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket.
The charge control LED
♦ The green charge control LED
the charging process is complete and the bat-
tery pack is ready for use.
PKSA 20-Li A1
to the high-speed
(see fig. A).
lights up red.
indicates that
ATTENTION!
♦ If the red charge control LED
means that the battery pack
ed and cannot be charged.
♦ If the red and green charge control LEDs
both flash, this means that the battery
pack is defective.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the tool
Attaching the battery pack:
♦ Push the battery pack
it clicks into place.
Removing the battery pack:
♦ Press the release button
battery pack.

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
♦ RED/ORANGE/GREEN = maximum charge
RED / ORANGE = medium charge
RED = low charge – charge the battery

Adding chain oil

WARNING!
► Always check the chain lubrication before
starting work.
► Never work without chain lubrication!
If the saw chain runs dry, the cutting equip-
ment may become irreparably damaged in a
short time.
NOTE
► Use only saw chain oil, preferably biode-
gradable. Do not use waste oil, motor oil, etc.
► While working, check whether the chain
lubrication is working correctly.
flashes, this
has overheat-
into the handle until
and remove the
to
as follows:
GB │ IE │
39 ■