Vibration And Noise Reduction; Behaviour In Emergency Situations; Residual Risks - Parkside Paghs 20-Li C4 Bedienungsanleitung

For sawing work on hillsides, always
stand in the area above the log .
To keep total control while sawing
through, reduce the pressure at the
end of the cut without loosening
your grip on the handles of the wood
cutter . Make sure the saw chain does
not touch the ground. After finishing
the cut, wait until the wood cutter
comes to a stop before removing it
there. Always switch off the motor
of the wood cutter before changing
between trees .
Dirt, stones, loose bark, nails, clips
and wires must be removed from the
tree .
Do not use any accessories
that are not recommended by
PARKSIDE. This can result in electric
shock or fire.
˜ Vibration and noise
reduction
To reduce the impact of noise and
vibration emission, limit the time of
operation, use low vibration and low-
noise operating modes as well as wear
personal protective equipment .
Take the following points into account
to minimise the vibration and noise
exposure risks:
Only use the product as intended by
its design and these instructions .
Ensure that the product is in good
condition and well maintained .
Use correct accessory tools for the
product and ensure they are in good
condition .
Keep tight grip on the handles/grip
surface .
Maintain this product in accordance
with these instructions and keep it
well lubricated (where appropriate) .
Plan your work schedule to spread
any high vibration tool use across a
longer period of time .
˜ Behaviour in emergency
situations
Familiarise yourself with the use of this
product by means of this user manual .
Memorise the safety warnings and
follow them to the letter . This will help to
prevent risks and hazards .
Always be alert when using this
product, so that you can recognise
and handle risks early . Fast
intervention can prevent serious
injury and damage to property .
Switch the product off and
disconnect it from the mains if there
are malfunctions. Have the product
checked by a qualified professional
and repaired, if necessary, before
you operate it again .
˜ Residual risks
Even if properly operating and handling
the product, some residual risks will
remain . Due to its construction and
build, the product may present the
following hazards:
Cuts
Hearing loss if working without
hearing protection .
Damage caused to your health
resulting from hand/arm vibrations if
the power tool is used over a longer
period of time or if it is not properly
used and maintained .
WARNING!
m
This product produces an
u
electromagnetic field during
operation! This field may under
some circumstances interfere with
active or passive medical implants!
To reduce the risk of serious
or fatal injury, we recommend
persons with medical implants
to consult their doctor and the
medical implant manufacturer
before operating this product!
GB/IE/NI/MT 15