Troubleshooting; Fault Correction - Parkside Paghs 20-Li C4 Bedienungsanleitung

Work to the left of the log and as
near as possible to the electric
chainsaw . As far as possible, the
weight of the saw should rest on the
log .
˜ Troubleshooting
Problem
Device does not
start
Inferior cutting
performance
Saw runs with
difficulty, chain
comes off
Chain becomes
hot, smoke
development
during sawing,
discolouration of
the rail
Possible cause
The battery pack
is empty or not
12 ] [
inserted
Defective On/Off
switch
[ 4 ]
Defective motor
Incorrectly mounted
saw chain
[ 10 ]
Saw chain blunt
10 ] [
Chain tension
insufficient
Chain tension
insufficient
Too little chain oil
Change position to saw off branches
on the other side of the trunk .
Branches sticking out are cut off
separately .

Fault correction

Check the charge level . and have
repairs carried out by a qualified
electrician, if necessary .
Have repairs carried out by a qualified
electrician, if necessary .
Mount saw chain correctly
Sharpen cutting teeth or place on new
chain
Check chain tension
Check chain tension
Chain lubrication
GB/IE/NI/MT 21