Puky Z2 Bedienungsanleitung Seite 14

Children's bicycle
1. 6 mm Allen key (ZL models) or a 13 mm
spanner (Z models)
2. 5 mm Allen key (only for ZL 18­3 models)
3. 15 mm spanner
4. Crosstip screwdriver
The tools are not part of the scope of delivery.
Assembly must be carried out with great cau­
tion and by an adult, to avoid any potential
subsequent accidents or injuries. Please take
your time when assembling the bike. In some
cases, it is necessary to tighten screws with a
prescribed torque. The torque value is stated
in Newton metres (e.g. 2 Nm). If the torque
with which a screw is tightened is too low, the
connection may still be too loose and therefore
unsafe. If the torque is too high, screws and
other parts may be damaged or destroyed.
Please contact your dealer or a workshop if
you have any questions.
First remove the plastic protective caps from
the cap nuts of the front and rear axle as well
as from the cantilever brakes at the front. Also
remove the plastic foil which has been used to
protect the cranks.
You will need the following tools for
assembly (Figure B):
14
Remove the handlebar padding from the han­
dlebar and unscrew (with just a few rotations)
the underlying screw at the stem with the aid
of a 6 mm Allen key (ZL models) or a 13 mm
spanner (Z models). Now you can remove the
plastic cover that protects the clamping cone
at the lower end of the stem shaft.
Figure 1: Insert the handlebar into the steer
tube (1). If this proves to be difficult, unscrew
the handlebar a bit further. Adjust the handle­
bar to the desired height, align at right angles
to the front wheel and lock it by pulling the
screw at the stem (2) with the aid of a 6 mm
Allen key (ZL models) or a 13 mm spanner
(Z model) (15 Nm).
Please pay attention to the marking of the min­
imum insertion depth of the stem shaft. Now
reattach the handlebar padding back onto the
handlebar.
Figure 2: Take the loose end of the brake
cable and insert the wedge into the predefined
recess on the brake handle (1). Then, carefully
pull the outer cover of the brake cable to en­
gage the end stop into the adjustment screw of
the brake handle (2).
When assembling the brake cable, please
make sure that the knurled screw of the brake
cable is situated straight in the holder of the
front light. Otherwise, the brakes cannot be
assembled correctly.