Radiated
10V/m
RF
& table
IEC
9
61000-4-3
NOTE 1
At 80 MHz and 800 MHz, the higher frequency range
applies.
NOTE 2
These guidelines may not apply in all situations. Elec-
10V/m &
Portable and mobile RF communi-
table 9
cations equipment should be used
not closer to any part of the device
, including cables,
than the recommended separation
distance calculated from the equa-
tion applicable to the frequency of
the transmitter.
Recommended separation distance
Where P is the maximum output
power rating of the transmitter in
watts (W) according to the trans-
mitter manufacturer and d is the
recommended separation distance
in metres (m).
transmitters, as determined by
an electromagnetic site survey,
should be less than the compliance
level in each frequency range.
Interference may occur in the vicin-
ity of equipment marked with the
following symbol:
39
80 MHz to 800 MHz
800 MHz to 2.5 GHz
a
b