Maintenance And Service; Maintenance And Cleaning - Bosch GST Professional 14,4 V-LI Originalbetriebsanleitung

OBJ_BUCH-1257-001.book Page 25 Thursday, July 15, 2010 9:04 AM
Parallel Guide with Circle Cutter (Accessory)
Parallel Cuts (see figure J): Loosen the locking
screw 24 and slide the scale of the parallel guide
through the lead 10 in the base plate. Set the
desired cutting width as the scale value on the
inside edge of the base plate. Tighten the lock-
ing screw 24.
Circular Cuts (see figure K): Set the locking
screw 24 to the other side of the parallel guide.
Slide the scale of the parallel guide through the
lead 10 in the base plate. Drill a hole in the work-
piece centred in the section to be sawn. Insert
the centring tip 26 through the inside opening of
the parallel guide and into the drilled hole. Set
the radius as the scale value on the inside edge
of the base plate. Tighten the locking screw 24.
Coolant/Lubricant
When sawing metal, coolant/lubricant should be
applied alongside cutting line because of the
material heating up.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool. There is danger
of injury when unintentionally actuating the
On/Off switch.
For safe and proper working, always keep
the machine and ventilation slots clean.
Clean the saw blade holder regularly. For this,
remove the saw blade from the machine and
lightly tap out the machine on a level surface.
Heavy contamination of the machine can lead to
malfunctions. Therefore, do not saw materials
that produce a lot of dust from below or over-
head.
Lubricate the guide roller 9 occasionally with a
drop of oil.
Check the guide roller 9 regularly. If worn, it
must be replaced through an authorised Bosch
after-sales service agent.
Bosch Power Tools
The plastic guide plate 6 should be replaced
when worn.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
After-sales Service and Customer
Assistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer service representatives can an-
swer your questions concerning possible appli-
cations and adjustment of products and acces-
sories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: boschservicecentre@bosch.com
Ireland
Origo Ltd.
Unit 23 Magna Drive
Magna Business Park
City West
Dublin 24
Tel. Service: +353 (01) 4 66 67 00
Fax: +353 (01) 4 66 68 88
1 609 929 W85 | (15.7.10)
English | 25