Linea 2000 DOMO DO253SW Gebrauchsanleitung Seite 51

CLEANING THE DIRTY WATER RESERVOIR
When the dirty water tank has reached its maximum level, the indicator light will turn red and you
will hear 2 beeps. Follow the steps below to clean the waste water tank:
1. Remove the waste water tank from the appliance using the release.
2. Remove the top of the tank and pour the contents into the sink. Use warm water and a mild
detergent to clean the tank. Dry thoroughly.
3. Remove dust and dirt from the filter. The filter can also be removed for even more thorough
cleaning. All parts can be rinsed under running water. Allow to dry thoroughly before
reassembling all parts.
4. After cleaning, place the top back on the tank. Make sure the top piece slides into the grooves
of the tank. Put the filters back in place. Then place the tank back into the unit, you will hear a
click when the tank is in place.
CLEANING THE SUCTION OPENING
1. Remove the roller from the nozzle. Remove the dirty water tank.
2. Clean the suction opening with the cleaning brush included. You can do this either from the
bottom up, through the nozzle, or from the top down, through the opening of the dirty water
tank.
3. Insert the cleaning brush into the nozzle, turn it and pull down, this way you can lower the
rubber water-stop valve from the nozzle. You don't have to take it out completely.
4. Pour some water into the opening of the dirty water tank to flush the pipes.
I
Be careful. Do not submerge the appliance in water. Do not allow water to enter the battery
compartment or into the motor unit.
5. After cleaning, place all parts back into the appliance – except for the roller. Do not push the
rubber water-stop valve back manually: it will be automatically drawn into place when the
appliance is switched on. Turn on the appliance at high speed without the roller until the valve
is properly seated. Then switch off the appliance and insert the roller.
www.domo-elektro.be 51