Cleaning And Maintenance - Linea 2000 Domo Do42104S Gebrauchsanleitung

• When you want to clean hard floors, make sure that the brushes in the floor nozzle are
down (A).
• When you want to clean carpet, make sure that the brushes in the floor nozzle are retracted
(B).
4. Slide the valve on the hose into the closed or open position to increase or reduce the suction
power. Slide the switch on the floor nozzle to 'deep clean' to effectively remove deeply-
ingrained dust from all types of floor.
5. When you have finished vacuuming, unplug the vacuum cleaner and automatically rewind the
cord by pressing the foot pedal with the
back and forth while rewinding the cord, by guiding the cord with your hand. This to prevent
possible damage.

CLEANING AND MAINTENANCE

CHANGING THE DUST BAG
The vacuum cleaner cannot be used without the dust bag. When the dust bag is full or damaged
you need to replace it immediately. The dust bag full indicator turns red when you need to replace
it.
1. Remove the flexible hose.
2. Open the top of the dust bag reservoir via the cover.
3. Remove the dust bag and place a new one in the correct position.
1
THE FILTERS
The appliance has 2 filters. In a normal cleaning session, it is sufficient to tap out the filters. It is
recommended that you thoroughly clean the filters under tepid running water 3 to 4 times per year.
Make sure that it is completely dry before putting it back in the appliance. You can also replace
them if necessary. Avoid direct sunlight or intense overheating. Never put the filters in the washing
appliance to prevent deformation. Do not use abrasive or cleaning products and wash from the
bottom of the filter.
HEPA filter
Remove the grill for the HEPA filter via the
cover provided. Take the HEPA filter out of
the appliance by pulling the clip towards
you. It is recommended that this filter be
replaced once a year. Place all the parts
back in the vacuum cleaner before using the
appliance again.
symbol. Make sure that the plug does not whip
2
www.domo-elektro.be
3
37