DynaVox SPARK II Bedienungsanleitung Seite 38

The loudspeaker cables must be attached directly,
without using cable connectors. Remove a piece of
the insulation about 1 cm long from each end of the
loudspeaker wire. Twist the bare wire in order to
prevent short circuits. Press the knob of the loud-
speaker clamp to open it and feed the bare wire
end into the clamp hole now exposed. Now release
the knob to secure the wire in the loudspeaker
clamp. You may check the correct fitting of the cable
by gently pulling the cable which you have just
installed.
Connection of the mains cable
Do not connect the mains cable until last. Please
check whether the power supply of the appliance is
compliant with the one in your household. Please
find the voltage and frequency information next to
the mains cable on the rear side of the appliance.
Connect the plug of the mains cable to a wall out-
let, if the power supply is compliant.
38