Bt Operations; Aux-In Operations - auna BC-10 Bedienungsanleutung

EN
22

BT OPERATIONS

Pairing a BT Device for the First Time
1. Power on the unit by pressing the STANDBY button. The power indicator
will light up and the BT indicator will flash. Press and hold the PAIRING
button for about 5 seconds. When pairing, remain within about 5
seconds.
2. Using the native controls on your BT device, select "BC10" in your BT
settings to pair. If your device requests a password, enter the default
password "0000" (four zeros). Refer to the user's manual for you specific
device for instructions on pairing and connecting BT devices.
3. When successfully paired and connected, a sound "Connected" will issue
from the unit and the BT indicator will remain lit. After initial pairing, the
unit will stay paired unless unpaired manually by the user or erased due
to a reset of the device. If your device should become unpaired or you
find it is unable to connect, repeat the above steps.
Playing Audio Wirelessly
1. After pairing to a BT device, use the native controls on the connected BT
device to select a track.
2. Play, pause or skip a selected track using the native controls on the
connected BT device.
3. Audio played through the connected BT device will now be heard
through the speakers.
4. Adjust the VOLUME control to obtain the desired volume level.
5. Press STANDBY button again to turn off the unit.

AUX-IN OPERATIONS

You can play other music sources (iPod, MP3 or other digital audio players)
through the speakers of this unit by connecting the AUX IN JACK to your
external player's audio out jack or headphone jack.
1. Plug one end of a 3.5mm audio input cable (not included) into the AUX
IN input on the rear of the unit, and plug the other end of the cable into
the audio output on the external music player or other source.
Note: Make sure your external music player is turn ON.
2. Press the STANDBY button to power the unit on and Power indicator will
light up.