Cleaning, Maintenance And Storage; Cleaning; Replacing The Batteries; Maintenance - Parkside Performance Phdp 180 D3 Originalbetriebsanleitung

4. Press the switch lever (21) on the trigger
gun (1) until the pressure has been re-
leased.
5. Pull out the plug. Wind the mains con-
nection cable (8) on the holder (9).
6. Disconnect the device from the water
supply.
Cleaning, maintenance and

storage

WARNING! Electric shock! Risk of injury
due to unintentional start-up. Protect your-
self when performing maintenance or clean-
ing work. Switch off the device and discon-
nect the mains plug from the socket.
You should have any repair and maintenance
work that is not described in these instruc-
tions carried out by our Service Centre. Only
use original replacement parts.

Cleaning

NOTICE! Risk of damage! Improper clean-
ing can damage the device. Never spray
down the device with water. Do not clean the
device under running water. Do not use any
abrasive cleaning agents or solvents.
Always keep the device clean.
Cleaning after operation
1. Move the On/Off switch (17) to the posi-
tion "0" (OFF).
2. Pull out the plug.
3. Keep the ventilation slits clean and free
of objects.
4. Clean the device with a soft brush or a
slightly damp cloth.
Cleaning the 3-in-1 nozzle
In rare cases, the 3-in-1 nozzle may become
clogged by foreign bodies.
1. Remove the 3-in-1 nozzle (27).
2. Adjust the 3-in-1 nozzle so that the
nozzle to be cleaned and the connection
are in a straight line.
3. Remove the foreign body from the front
using the nozzle cleaning needle (34).
4. Rinse the 3-in-1 nozzle with water from
the front to remove the foreign body.
Cleaning the filter insert in the water con-
nection
1. Remove the coupling (15) from the water
connection (13).
2. Remove the filter insert (14) from the wa-
ter connection.
3. Clean the filter insert under running wa-
ter.
4. Fit the filter insert (14) and coupling (15)
in reverse order.

Replacing the batteries

Replace the batteries if the LC display (19) is
not displaying anything.
Power tools required
• Phillips screwdriver (not included)
Replacing the batteries
1. Remove the screw from the battery com-
partment cover (20).
2. Remove the cover of the battery com-
partment.
3. Replace the batteries (36) in the battery
compartment with new batteries. Pay at-
tention to the correct polarity when in-
serting the batteries in the battery com-
partment.
4. Press the switch lever (21) on the trigger
gun (1).
The LC display shows the selected pres-
sure. If the LC display is not displaying
anything, check whether the batteries are
inserted correctly.
5. Insert the cover of the battery compart-
ment.
6. Fasten the cover of the battery compart-
ment using the screw.

Maintenance

The device is maintenance free.
Storage
Notes
Always store the device and accessories:
• clean
• dry
• protected against dust
• protected against frost
• out of the reach of children
Preparing the device for storage
NOTICE! The pressure washer and accessor-
ies will be destroyed by frost if they are not
completely emptied of water.
1. Completely empty the water from the
device.
• Disconnect the device from the water
supply.
GB
MT
35