Unit Description; Operation - Beurer IL 50 Gebrauchsanweisung

• Please make sure the unit is not placed on flammable
materials such as table cloths or carpets.
• Do not leave any easily flammable or meltable items
close to the unit.
• Do not hang the unit on the wall or from the ceiling.
• Do not use the unit in the open air.
• Protect the unit from strong impacts.
Before starting
Important
• Before you use the unit for the first time, remove all
packaging materials.
• Check the unit for signs of use or damage. If in doubt
and the unit is damaged, do not use it and contact
your dealer or the customer service address provided.
• The manufacturer is not liable for damage caused by
improper or incorrect use.
• Protect the unit from dust, dirt and moisture.
Repairs
Warning
Danger of an electric shock!
• Open the unit only to change the lamp. Do not at-
tempt to repair the unit, otherwise problem-free op-
eration cannot be guaranteed. Failure to observe this
condition will void the warranty.
• For repairs, contact Customer Service or an author-
ised dealer.

4. Unit description

Overview
Item Name
1 Swivelling body with handles
2 Disc
3 On/Off switch
4 Remaining time display
5 Time selector
6 Foot with integrated cable channel for coiling the
power cable.
Infrared radiant heater with adjustable timer (1 to 15
minutes) and swivelling body (0 to 50 degrees).
• The timer switches off automatically at the end of the
set time.
• The swivelling body allows you to adjust the infrared
radiant heater to suit your needs.

5. Operation

Unpacking and set-up
Warning
• Remove all packaging materials before using the
unit.
• Unwind the power cable fully.
• Place the unit on a solid and even surface.
• Maintain a distance of at least 1 metre from other
objects, both to protect the unit itself from overheat-
ing and to prevent the risk of fire or burning.
• Do not hang the unit on the wall or from the ceiling.
• Insert the mains plug in the socket.
• Switch on the unit at the On/Off switch (3). The re-
maining time display (4) shows 15 minutes.
Warning
• Do not bump the unit while it is operating or cooling
down or you could damage the lamp.
• Set the desired treatment time (1 to 15 minutes) by
pressing the time selector (5) several times.
• The set time will appear on the display (4).
Preparing for treatment
• Arrange yourself in front of the unit so you can relax
and enjoy the treatment of the part of the body con-
1
cerned.
• Tilt the lamp so the unit is angled directly at the part
2
of the body being treated.
• The distance to the infrared radiant heater depends
largely on personal heat sensitivity and the treatment
3
concerned.
• Make sure the distance between the infrared radi-
ant heater and the part of the body being treated
4
is not less than 30 cm!
• Protective eyewear which corresponds to DIN EN 171
5
2002 must be worn for treatment distances under 80
6
cm. For treatment distances above 80 cm, closing
your eyes is sufficient.
CAUTION: Never look directly into the infrared light
without protective eyewear.
Do not use the unit for more than 15 minutes at a time
(risk of overheating). Allow the unit to cool down before
you use it again.
10