Unit Description; Initial Use; Positioning The Device - Beurer TL 50 Gebrauchsanweisung

• Protect the unit from strong impacts.
• Do not pull the mains part out of the socket using the mains cable.
• If the mains part or its housing is damaged, this must be replaced by customer services or the retailer, as
a special tool is needed for repair.
• Disconnection from the power supply network is only guaranteed when the mains part is unplugged.
• Do not use the device in the presence of flammable anaesthetic gas connections with air, oxygen or nitro-
gen oxide.
• No calibration and no preventative checks or maintenance is to be carried out on this device.
• You cannot repair the device. The device contains no parts that you can repair.
• Do not make any changes to the device without the manufacturer's permission.
• If the device has been changed, thorough tests and checks must be carried out to ensure the continued
safety of further use of the device.
• Do not position the device in a location where it is difficult to disconnect it from the mains supply.
• Check the device before each use. Do not use the device if it is damaged in any way.
The continuous use of a damaged unit can be dangerous and may cause injury or improper results.
• The main material of the case is made of PC/ABS. Be cautious of potential allergic reactions to these ma-
terials.
General notes
Important
• If you are taking medication such as pain relievers, antihypertensives or antidepressants, consult your
doctor before using the daylight therapy lamp.
• People with retinal diseases as well as diabetics need to be examined by an ophthalmologist before be-
ginning to use the daylight therapy lamp.
• Please do not use if you have an eye disease such as cataracts, glaucoma, diseases of the optic nerve in
general and inflammation of the vitreous humour.
• If you have health concerns of any kind, contact your general practitioner!
• Before you use the unit for the first time, remove all packaging materials.
• The lamp tubes are excluded from the warranty.
Repairs
Important
• Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious inju-
ries. Failure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer service or an authorised dealer.

4. Unit description

Overview
1. Fluorescent screen
2. Rear of the device housing
3. ON/OFF button
4. Mains part connection

5. Initial use

Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact customer services or your supplier.

Positioning the device

Place the device on an even surface. The position should be chosen to ensure a distance of between 15 cm and
35 cm between the user and the device. The lamp is most effective at this distance.
1
11
3
2
4