Accessories - Kärcher BR 60/95 RS Bp Pack Bedienungsanleitung

Fault
Appliance cannot be started
Device does not drive or
drives only slowly
Device does not brake
No or inadequate suction
power
Insufficient cleaning result
Brushes do not turn
No or very little detergent so-
lution gets added
Description
Battery changing kit
Battery
Charger
Description
Brush roller, white (soft)
Brush roller, red (medium, standard) 8.628-389.0 Also for regular cleaning of heavily dirtied floors.
Brush roller, green (hard)
Remedy
Insert the battery plug on the device.
Release emergency-stop button by turning.
Check battery cable for correct sitting.
Reset control fuse (only BR).
Check battery cable for corrosion; clean, if required.
Battery capacity exhausted; recharge battery.
Check main fuse, replace if required
Press the unlocking key.
Release accelerator pedal, turn the key switch to "0", turn the key switch to "1", press
the safety pedal, press unlocking key, press accelerator pedal.
Reset fuse of traction drive
Control overheated; switch off the device and let it cool down for 15 minutes.
Front wheel does not grip in due to high brush contact pressure; reduce brush contact
pressure.
Deactivate immobilising brake; press the unlocking lever upward to activate it.
Reset suction turbine fuse (only BR).
Empty the dirt water reservoir.
Check the setting of the vacuum bar.
Clean the seals between dirt water reservoir and cover and check for tightness, replace
if required.
Clean the vacuum lips on the vacuum bar, turn or replace if required
Check suction hose for blockages; clean if required.
Check connection between suction hose and vacuum bar and suction hose and lid of
the dirt water tank.
Check the suction hose for tightness; replace if required.
Check if the cover on the dirt water discharge hose is closed
Check the setting of the vacuum bar.
Clean the floater in the dirt water tank.
Set/ adjust contact pressure.
Check the brushes for wear, replace if required.
Check brushes for wear and tear, clean.
Check whether the detergent and brushes are suitable for the cleaning task.
Reset fuse of brush drive.
Check the brushes for blockage due to foreign particles, remove them if found.
Check level of detergent solution in the fresh water tank; refill, if required.
Reset pump fuse (only BR).
Increase detergent dosing.
Check fresh water sieve and filter; clean if required.

Accessories

Part no.: Description
8.601-121.0 consists of: battery trough, cable set, locking set, 2
transport cars
6.654-141.0 12V/105 A, maintenance-free (Gel),
6.654-229.0 36V, for maintenance-free batteries
Part no.: Description
8.628-390.0 For polishing and cleaning sensitive floors.
8.628-391.0 For thoroughly cleaning heavily dirtied floors and for
removing the coating (for e.g. of wax, acrylate).
Faults
BR
By whom
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Piece Machine
requires
piece
1 1
1 3
1 1
Piece Machine
requires
piece
1 1
1 1
1 1
English 23