Putting Into Operation; Fault And Error Messages; Alarm Stop - pyrexx PX-1 Betriebsanleitung

6
Putting into
operation
Note the following when putting into
operation:
(1) Push the splint pin sideways off of
activation button.
(2) Push activation button flush.
Short acoustic signal
5 The device is activated.

Alarm stop

You can stop an alarm with or without fire.
If there is still a risk of fire after
an alarm stop, the switched-off
devices ring again after 10 minutes.
You can stop the alarm directly on
the device:
f Press the testing/stop button on the
device.
5 Alarm is stopped.
EN
EN
Operating Manual: PX-1 - Smoke Alarm Device
7 Fault and error
messages
The device automatically checks its opera-
tional readiness once a minute. The device
displays functional limitations in the form of
error and alarm messages.
If the device detects environmental influences
differing from the rule, it regulates the sensi-
tivity of its detection electronics automatically.
7.1 Error messages
The following messages are considered
error messages:
Battery error message
•
Contamination message
•
Alarm without cause of fire
•
DANGER
Danger from malfunction!
In the event of a battery error
message/contamination message, the
smoke alarm device may only con-
tinue to provide its reliable warning
performance for max. 60 days.
f It is necessary to replace the
smoke alarm device before the
remaining 60 days have passed.
49