Faults And Repairs; Replacing The Oven Light Bulb - Blaupunkt 5CD331.0 Gebrauchsanleitung

Clean the hook-in rack with washing-up liquid and a sponge
3.
or brush.
Align the hook-in rack with the kink (a) facing upwards, so
4.
that the shelf positions match.
Insert the hook-in rack at the rear as far as it will go.
5.
Push the hook-in rack towards the rear.
6.
Insert the hook-in rack at the front as far as it will go.
7.
Push the hook-in rack downwards.
8.

Faults and repairs

It is not always necessary to call the after-sales service.
Sometimes, you can find a remedy yourself. You will find some
tips for troubleshooting in the following table.
Problem
Electrical function is faulty (e. g. indicator
lamps do not light up)
Liquid or thin dough runs to one side
Smoke is generated during roasting or grill-
ing
Higher levels of condensation are gener-
ated in the cooking compartment
Enamelled accessories have matt, light-
coloured marks
Door panels are misted up

Replacing the oven light bulb

Replace faulty oven light bulbs.
You can obtain replacement light bulbs from customer service
or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to
300 °C. Only use these oven light bulbs.
:
Risk of electric shock !
Disconnect the appliance from the power supply. Switch off the
circuit breaker or remove the fuse from the household fuse box.
Place a tea towel in the cold cooking compartment to prevent
1.
damage.
Turn the glass cover anticlockwise and remove it.
2.
Replace the oven light bulb with a bulb of the same type.
3.
Screw on the glass cover again.
4.
Remove the tea towel and switch on the circuit breaker.
5.
60
:
Work on the appliance electronics may only be performed by
■
a specialist.
Always disconnect the appliance from the power supply
■
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Possible cause
Circuit-breaker faulty
Appliance not installed level
Fat is burning on the grill element
Wire rack or universal pan inserted incor-
rectly
Normal occurrence (e. g. when baking
cakes with very moist toppings or roasting
a large joint)
Normal occurrence caused by dripping
meat or fruit juices
Normal occurrence caused by tempera-
ture differences
Note: If the glass cover cannot be unscrewed: use rubber
gloves to turn it. You can order a special removal tool through
the after-sales service (order no. 613634)
Changing the door seal
If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service.
The door seal is attached in four places (figure A). When
replacing it, disconnect and attach the hooks at all four points
(figure B).
Check again to ensure that the seal is seated correctly in the
corners in particular.
Risk of electric shock!
Remedial action
Check circuit-breakers in the fuse box and
replace if necessary
Check the appliance installation (see the
Installation instructions)
Continue grilling or roasting until the fat on
the grill element is burnt away
Check the shelf levels (see section: Roast-
ing or Grilling)
Open the appliance door briefly from time
to time during operation
Not possible
Heat the appliance up to 100 °C and then
switch off again after 5 minutes