Electrical Connection - RIKA Domo Montageanleitung

Dimensions of DOMO
RO-T3
B
Dimensions
Height
Width
Corpus Depth
Weight
Weight without shell
Weight with steelshell
Weight with stones
Weight with decor side panels
Flue pipe connection
R - Ø Flue Pipe Outlet
R - H Rear Connection Height
R - S Rear Connection - side Distance
RO - H Top connection Height
RO - T3 Top connection - Distance to rear wall
RO - S Top connection - side Distance
Fresh air connection
F - Ø Diameter
F - H Connection Height
F - S Side Distance
Amount of fuel
Nominal load
Amount of fuel
Burn time at full pellet
hopper
*Practical values may vary depending on pellet quality.
Note
Pellet consumption depends on the size of the pellets. The larger the pellet,
the slower the feed and vice versa.
RO-S
F-
T F-S R-S
[mm] 1120
[mm]
[mm]
[kg] ~170
[kg] ~185
[kg] ~230
[kg] ~180
[mm]
[cm]
[cm]
[cm]
[cm]
[cm]
[mm]
[cm]
[cm]
Part load
~2,3 kg* ~0,8 kg*
ca. 20 h ca. 60 h
Technical data for DOMO
Technical data
Heating power range
Room heating capacity (depending on house
insulation)
Fuel consumption
R-
Pellet container capacity
Electric supply
Average electrical input
Fuse
Efficiency
CO
2
CO-emission on 13% O
793
Dust emission
431
Exhaust
Exhaust temperature
Chimney draft requirement
The owner of small firing systems or the person authorised for the small
firing system is to keep the technical documentation and is to submit it to the
authorities or the chimney sweep on request.
Note
Please observe the national and European standards as well as local
regulations concerning the installation and operation of firing installations!
100
28
Packaging
26
Your first impression is important to us!
37
The packaging of your new stove provides excellent protection against damage.
However damage to the stove and accessories may still occur during transport.
6
28 Note
Therefore please check your stove on receipt for damage and completeness!
Report any deficiencies to your dealer immediately! Pay particular attention
during unpacking that the stone panels remain intact. Scratches to the
50
material can easily occur. Stone panels are excluded from the warrant.
38
The packaging of your new stove is environmentally neutral to a great extent.
28
Tip
The wood used in the packaging has not been surface treated and may
therefore be burnt in your woodburning stove (not in pellet stoves!). The
cardboard and film (PE) can be depolluted via the municipal waste collection
for recycling.

Electrical connection

The stove is supplied with an approx. 2 m long connecting cable with a Euro-
plug. This cable is to be connected to a 230 Volt/50 Hz socket. The average
electrical power consumption is about 20 Watt in heating operation and approx.
150 Watt during automatic ignition. The connection cable must be laid in a way
that there is no contact to any sharp edges or hot surfaces of the stove.
[kW]
[m³]
[kg/h]
[l]/[~kg]
[V]/[Hz]
[W]
[A]
[%]
[%]
[mg/m
2
[mg/m
[g/s]
[°C]
[Pa]
3-10
70-260
till 2,3
76/~50
230/50
~ 20
2,5 AT
92,7
11,8
] 46
3
N
] 18
3
N
6,6
135,5
3
|29
28