Technical Specifications; Electrical Connection - RIKA Interno Montageanleitung

Dimensions
Dimensions
H - height
B - width
T - corpus depth
Mounting dimensions
H - E height (min.)
B - E width (min.)
T - E corpus depth (min.)
Weight
Weight of the stove
Weight of the base plate for mounting
Flue pipe connection
R - Ø flue pipe outlet
RO - H original angle pipe connection height
RO - T1 original angle pipe total depth
RO - T2 original angle pipe distance to rear wall
RO - T3 deapth from rear wall to middle of flue
pipe
RO - S original angle pipe side distance
R - H rear connection height
R - S rear connection side distance
Fresh air connection
F - Ø diameter
F - H connection height
F - S side distance
F - T connection depth
Amount of fuel
Nominal load
Amount of fuel
Burning time at full
pellet hopper
*Practical values may vary depending on pellet quality.
Note
Pellet consumption depends on the size of the pellets. The larger the pellet,
the slower the feed and vice versa.
[mm] 617/686
[mm] 790/920
[mm]
[mm]
[mm]
[mm]
[kg]
[kg]
[mm]
[cm]
[cm]
[cm]
[cm]
[cm]
[cm]
[cm]
[mm]
[cm]
[cm]
[cm]
Part load
~ 1,6 kg* ~ 0,6 kg*
14h* 40h*
Technical specif ications
Technical data
Heating power range
Room heating capacity (depending on house
insulation)
Fuel consumption
Pellet container capacity
Electric supply
Average electrical input
Fuse
Efficiency
CO2 content
CO-emission on 13% OO
Dust emission
Exhaust
580
Exhaust temperature
Chimney draft requirement
560
The owner of small firing systems or the person authorised for the small
firing system is to keep the technical documentation and is to submit it to the
690
authorities or the chimney sweep on request.
510
Note
Please observe the national and European standards as well as local
140
regulations concerning the installation and operation of firing installations!
30
Packaging
Your first impression is important to us!
100
The packaging of your new stove provides excellent protection against damage.
26
However damage to the stove and accessories may still occur during transport.
7
Note
-
Therefore please check your stove on receipt for damage and completeness!
Report any deficiencies to your dealer immediately! Pay particular attention
-
during unpacking that the stone panels remain intact. Scratches to the
material can easily occur. Stone panels are excluded from the warrant.
11
17
The packaging of your new stove is environmentally neutral to a great extent.
11
Tip
The wood used in the packaging has not been surface treated and may
therefore be burnt in your stove, but not in the pelletstove. The cardboard and
50
film (PE) can be disposed of via the municipal waste collection for recycling.
14
30

Electrical connection

6
The stove is supplied with an approx. 2m long connecting cable with a Euro-plug.
This cable is to be connected to a 230Volt/50Hz socket. The average electrical
power consumption is some 50 Watt in heating operation. And approx. 150
Watt during automatic ignition. The connection cable must be laid so that there
is no contact to any sharp edges or hot surfaces of the stove.
[kW] 2,5 - 7
[m³] 50 - 160
[kg/h] up to 1,6
[l/kg] 36/~20
[V]/[Hz] 230/50
[W] ~ 50
[A] 2,5 AT
[%] 90,1
[%] 12,2
[mg/m ] 60
3
N
[mg/m ] 14
3
N
[g/s] 4,5
[°C] 173,2
[Pa] > 3