RIKA Domo Montageanleitung Seite 34

Dimensions
Convection Air Connection
Ø Diameter
K1 - H Connection Height
K1 - S Side Distance
K2 - H Connection Height
K2 - S Side Distance
Note
Only work on the unit when the mains plug has been disconnected and the
stove has cooled down completely.
Note
During assembly / dismantling do not allow objects (screws etc.) to fall into
the pellet container – they can block the screw conveyor and damage the
stove.
Note
During any conversion work, take particular care of your fingers and any
panels and stove attachments. Select soft bases to prevent scratches to your
living space furniture and stove panels.
General information
The convection air amount and temperature is designed for heating one or,
Q
if two fans are installed, two additional rooms.
Note the regional specific fire safety regulations and clarify the connection
Q
situation with the competent authority.
The max. temperature of the convection air is 180° C at the air outlet.
Q
The convection air duct should be as short as possible.
Q
Keep the number of deflections as small as possible.
Q
Note
Please pay attention to the national and country-specific building and fire
regulations when connecting the convection air pipes. Installation and
assembly must be performed by a trained specialist only.
The option MultiAir is basically only with the lower flue pipe connections (rear
/ rear center / side) possible. If only one convection fan is mounted, it can be
combined with the increased rear connections. In this case, leave out the lower
air deflector.
K 2 -S
K 1 -S
[mm] 100
[cm] 80
[cm] 30
[cm] 51
[cm] 22
Mounting Convection Fan
Prepare the following at the stove:
Loosen the 4 screws on the rear panel. The rear panel tilts backwards, then
you can lift it off.
Depending on the desired option cut off the two upper markers for one fan, for
the second fan in addition the two bottom markers.
The pre-assembled fan unit must be disassembled for installation. Loosen the
screws and remove the entire fan housing with motor and the oval sensor cover.
Remove the cable cover which is secured with cable ties.
Now mount the lower air deflector on the support plate of the fan.
Loosen the screw of the flame sensor. Remove the flame sensor and the
silicone hose from the pressure pipe as well.
#25
#8
#10
#8
#8