Technical Data - RIKA Look RLU Montageanleitung

Dimensions
RO-T2
B
Dimensions
Height
Height with wooden bench
Width
Width with wooden bench
Corpus depth
Weight
Weight
Weight with wooden bench
Flue pipe connection
R - Ø Flue pipe outlet
RO - H original angle pipe connection
height
RO - H with wooden bench
RO - T1 original angle pipe total depth
RO - T2 original angle pipe distance to
rear wall
RO - T3 Deapth from rear wall to middle
of flue pipe
RO - S original angle pipe side distance
R - H Rear Connection Height
R - H with wooden bench
R - S Rear Connection Side Distance
Fresh air connection
F - Ø Diameter
F - H Connection Height
F - H Connection Height with bench
F - S Side Distance
Note
Please observe the national and European standards as well as
local regulations concerning the installation and operation of
firing installations!
R-
RO-T3
T
F-
RO-T1
[mm]
[mm]
[mm]
[mm]
[mm]
[kg]
[kg]
[mm]
[cm]
[cm]
[cm]
[cm]
[cm]
[cm]
[cm]
[cm]
[cm]
[mm]
[cm]
[cm]
[cm]
Amount of fuel
RO-S
Amount of fuel
*Practical values may vary depending on fuel quality.
R-S

Technical data

Technical data
Heating power range
Room heating capacity (depending on
house insulation)
Fuel consumption
F-S
Electric supply
Average electrical input
Fuse
Efficiency
CO
2
CO-emission on 13% O
Dust emission
Exhaust
Exhaust temperature
~
Chimney draft requirement
~
The owner of small firing systems or the person authorised for the
small firing system is to keep the technical documentation and is to
submit it to the authorities or the chimney sweep on request.
Packaging
Your first impression is important to us!
The packaging of your new stove provides excellent protection
against damage. However damage to the stove and accessories
may still occur during transport.
Note
Therefore please check your stove on receipt for damage and
completeness! Report any deficiencies to your dealer immediately!
Pay particular attention during unpacking that the stone panels
remain intact. Scratches to the material can easily occur. Stone
panels are excluded from the warrant.
The packaging of your new stove is environmentally neutral to a
great extent.
Tip
The wood used in the packaging has not been surface treated
and may therefore be burnt in your woodburning stove (not in a
pelletstove!). The cardboard and film (PE) can be depolluted via
the municipal waste collection for recycling.
Electrical connection (RIKATRONIC3)
The stove is supplied with an approx. 2 m long connecting cable
with a Euro-plug. This cable is to be connected to a 230 Volt / 50 Hz
socket. The average electrical power consumption is about 4 Watt in
heating operation, and approx. 150 Watt during automatic ignition.
The connection cable must be laid in a way that there is no contact
to any sharp edges or hot surfaces of the stove.
Nominal load Part load
~ , kg*
[kW]
[m ]
[kg/h]
[V]/[Hz]
[W]
[A]
[%]
[%]
[mg/m
2 N
[mg/m
N
[g/s]
[°C]
[Pa]
~ , kg*
-
-
up to ,
/
~
, AT
,
,
]
]
,
,