Arai RX-7V FIM Racing #2 Gebrauchsanleitung Seite 20

Left chinstrap cover (D-ring side)
Cache gauche de la jugulaire (côté anneau en forme de D)
Linke Kinnriemenabdeckung (D-ring seite)
20
4
5 6
1 2
Right chinstrap cover (long side)
Cache droit de la jugulaire (côté long)
Rechte Kinnriemenabdeckung (lange seite)
English
NOTE:
The lining is equipped with a 5mm surface foam layer. The layer is
removable to offer a bit more room if desired. Gently remove it from the pad.
Once removed this foam layer will not reattache securely (4).
To wash the comfort lining, put it into lukewarm water with small amount of laundry
soap or your own shampoo and wash gently by hand. Rinse well with fresh water
and wipe off with a soft cloth. Dry it in the shade at ambient temperature.
WARNING: Never use petrol, thinner, benzene or any other solvents.
To replace the lining, place the bosses over their plastic receptacles and push
them home (5)&(6).
WARNING:
When reinstalling the comfort lining, be sure the lining is
properly positioned along the inside shape of the EPS (a.k.a. Styrofoam)
liner. If the comfort lining is not properly installed, the frame of the comfort
lining may fold when you put on and take off the helmet, which may injure
your skin, etc. Whenever you feel something is wrong with the comfort
lining, check that the lining is properly installed.
TO REMOVE/REPLACE CHINSTRAP COVERS
To remove the chinstrap covers, first remove the cheek pads as per previous
instructions.
Remove the plastic chinstrap anchor cover from the steel chinstrap anchor (1)
and slide the cover off the chinstrap (2).
Note the right and left, inside and outside of the chinstrap covers for
replacement.
To wash the chinstrap covers, put them into lukewarm water with small
amount of laundry soap or your own shampoo and wash gently by hand. Rinse
well with fresh water and wipe off with a soft cloth. Dry them in the shade at
ambient temperature.
WARNING: Never use petrol, thinner, benzene or any other solvents.