Arai RX-7V FIM Racing #2 Gebrauchsanleitung Seite 16

1
1
16
1 2 When first servicing the cheek pads, it is suggested that you do only one at a time so
that the other can be used as a reinstallation guide.
To remove the cheek pads, first undo chinstrap.
Gently pull the cheek pad toward the front of the helmet, then pull the back of the
cheek pad inward to release and slide it off the strap.
To take off the fabric covering for washing, peel the covering off over the rear edge of
2
the cheek pad assembly until all the fabric is on the face side surface. Then draw the
covering through the opening by grasping the rectangular collar and pulling.
To wash fabric coverings, put them into lukewarm water with small amount of laundry
soap or your own shampoo and wash gently by hand. Rinse well with fresh water and
wipe off with a soft cloth. Dry them in the shade at ambient temperature.
To replace fabric covering, first ensure the cover is turned right side out with the
2 3
EMERGENCY tab drawn through the slot, making sure it is not twisted. Next, stretch the
cover over pad and adjust it to lie smoothly. Then push the rectangular collar through
the pad assembly, making sure it is not twisted, and adjust into final position.
English
NOTE: The cheek pad is equipped with a 5mm surface foam layer. The layer is
removable to offer a bit more room if desired. Gently remove it from the pad.
Once removed this foam layer will not reattach securely.
WARNING :
Never use petrol, thinner, benzene or any other solvents.