Arai RX-7V FIM Racing #2 Gebrauchsanleitung Seite 10

1
5
4
7
10
10
2
6
8
11
English
TO REMOVE/REPLACE SHIELD
To remove, place shield in the fully open position
3
release lever from the front edge of the side pod backward
the side pod .
(3)
Then lower the shield until the brass stud of the shield moves into the red
hole of the base plate (4) . Remove the shield from the spring clips
and repeat for the other side.
To replace, position the shield on the base plate so that the lower part of
9
the sliding slot of the shield is over the spring clip of the base plate and the
brass stud is in the red hole of the base plate
spring clip, and then fully raise the shield until the brass stud falls into the
sliding slot of the base plate
the side pod into the top tab of base plate
recess of the helmet shell and push the lower part of the side pod down
firmly until it clicks into place and is fully captured by the base plate
12
Repeat for the other side. Work the shield up and down to confirm proper
operation .
(12)
. Push the side pod
(1)
. Press the shield onto the
(7)
&
. Position top hook on the backside of
(8) (9)
, align the side pod with the
(10)
(2) to release
&
(5) (6) ,
.
(11)