Signaling Lamps; Accessories Supplied With The Unit - Technibel REVE 245SCH2O Bedienungsanleitungen

1. Wireless remote control unit

2. Signaling lamps

3. Supply air deflector
4. Lateral air intake grilles
5. Front air intake grille
6. Air filter
7. Electric cable with plug
8. Inlet/outlet hole for municipal water and condensate drainage
9. Suspension panel
10. Service tube for condensate discharge
9
SIGNALING LAMPS
NOTE
I flash contemporary of the 3 spies: TIMER, ATTENDED
AND OPERATION, indicates that the operating mode
selected ( ) is not compatible with the unit. If this
happen the air conditioner does not operate until the
correct mode is selected.
WARNING
The OFF position does not disconnect the power. Use
the main power switch to turn off power completely.

ACCESSORIES SUPPLIED WITH THE UNIT

1. FULL SCALE DIAGRAM (1pcs.)
2. RAWL PLUGS + SCREWS (15pcs.)
3. REMOTE CONTROL UNIT (1pcs.)
4. BATTERIES FOR REMOTE CONTROL (2pcs.)
8
7
3
5
6
1
10
1. Receiver : receives signals transmitted from the remote
control.
2. Timer lamp: This lamp lights up when the system is
being controlled by the timer or sleep mode.
3. Standby lamp: This lamp lights up when the air
conditioner is connected to the power and ready to
receive the remote control command.
4. Operation lamp: This lamp lights up during operation.
It blinks once to announce that the remote control signal
has been received and stored. It blinks continuously
during the protection modes (defrosting, etc.).
5. Operation button (without remote control): Push the
button to change from one operation mode to the other
as shown here following.
Cooling only models
2
3
4
2
3
4
EG
Heat pump models
1