Overview Of The Machine - Ruris R-Power Is4000Rc Handbuch

EN
1. Tank cap
2. Handle
3. Control panel
4. Starter
5. Motor switch
6. Side cover screw (maintenance)
7. Button for electric start
The images are informative, the supplier reserves the right to make structural and functional changes to
the machine presented in this manual.
Warning system for low engine oil level (yellow LED)
This system will automatically shut down the engine if there is not enough oil in the crankcase. Before restarting
the engine, add oil to the upper limit.
If warning light for low engine oil level (yellow light), flashes for a few seconds, it means there is not enough oil
in the crankcase. Add oil to the upper limit and restart the engine.
Overload indicator (red LED)
When the overload indicator is lit, the generator detects that its output has been overloaded, causing the
converter to overheat or the AC voltage to rise, and the generator will shut down. When the AC LED (green) is
off, but the overload indicator (red) is on, the motor will not stop.
If the overload LED is on and no load is connected to the generator, complete the following steps:
1. Disconnect consumers from the generator and stop the engine.
2. Make sure that the total power of the connected electrical equipment does not exceed the power of the
generator
3. Check and clean the air vents (if applicable).
4. Restart the engine after checking.
Note: When using electrical equipment that requires high starting current (such as compressor or submersible
pump...), the overload LED may flash for a few seconds.
AC voltage indicator (green led)
The green light will illuminate while the engine is running and delivering normal power.
4

4. OVERVIEW OF THE MACHINE

1. LED indicators
2. Digital panel
3. Fuse (Ac Breaker)
4. AC outlet sockets
5. 12V DC sockets
6. ECO switch