Instructions For Use; Starting The Engine - Ruris R-Power Is4000Rc Handbuch

EN
▪ Starting the engine with repeated knocks or noise can cause engine damage.
It is not recommended to run the engine with knocking or noise, as it can cause damage to parts or even the
machine, this is not covered by the warranty (it is considered incorrect use).
Use quality fuel from authorized Peco stations.
Fill with the best quality UNLEADED PETROL fuel, using a metal funnel, in open areas and away from sources
of fire or sparks that could cause a fire.
WARNING!
Do not feed on the ground or near plants, as you risk damaging the environment.
Safety fuel handling
CAREFUL!
This fuel is extremely flammable. Do not smoke or bring flame or sparks near fuel.
!IMPORTANT
1. Stop the engine before refueling.
2. Move at least 3 meters away from the fuel point before starting the engine.
3. Using an inappropriate fuel will cause severe damage to the internal parts of the engine in a short time.
CHECKING THE AIR FILTER
Check the air filter to make sure it is clean and working.
•
Remove the generator side cover
•
Open the air filter cover and remove the air filter element. If
necessary, clean or replace it. Clean the filter element with
neutral solvents, dry it and then soak it in a film of oil. Remove
excess oil by squeezing.
•
The engine is not allowed to run without an air filter element, otherwise dirt will
enter the engine through the carburetor and cause rapid wear.

STARTING THE ENGINE

● It is strictly forbidden to use the generator in indoor and closed spaces.
Manual start
1. Disconnect the consumers from the generator
2.Turn the engine switch to the "CHOKE" (START)
position.
Note: When the engine is hot or the ambient temperature
is higher, the shock should not be used, turn the engine
switch to the "RUN" position.
3. Pull the starter handle smoothly until resistance is felt,
then pull steadily. Do not let the starter handle jerk back
toward the engine. Return gently to prevent damage to the
handle or case.
4. After the engine has started, turn the engine switch to the (RUN) position.
6

6. INSTRUCTIONS FOR USE

Filter
element
Filter
cover