Pre-Operation Checks - Ruris R-Power Ge9000Rc Ats Handbuch

EN
2. Add fuel when the level is low.
Do not exceed the filter shoulder.
WARNING!
▪ Gasoline is extremely flammable and is explosive
under certain conditions.
▪ Refuel in a well-ventilated area with the engine off.
Do not smoke or allow flames or sparks in the area
where the engine is being fueled or where gasoline
is stored.
▪ Do not fill the fuel tank (there should be no fuel in
the filler neck). After refueling, check the fuel tank
cap. It must be closed properly.
▪ Be careful not to spill fuel when refueling. Spilled fuel or fuel vapors can ignite. If you spill fuel, make sure the
area is dry before starting the engine.
▪ Avoid repeated or prolonged skin contact or breathing of gasoline vapors.
▪ Starting the engine with repeated knocking or noise may cause damage to the engine.
It is not recommended to run the engine with knocking or noise, as it may cause damage to parts or even the
machine, this is not covered by the warranty (it is considered incorrect use).
Use quality fuel from authorized Peco stations.
Refuel with the highest quality UNLEADED GASOLINE, using a metal funnel, in open spaces and away from
sources of fire or sparks, which could cause a fire.
WARNING!
Do not feed on the ground or around plants as you risk damaging the environment.
5.3 Safety fuel handling
This fuel is extremely flammable. Do not smoke or allow flames or sparks near the fuel.
1. Turn off the engine before refueling.
2. Using the wrong oil can lead to spark plug fouling, exhaust blockage, or piston ring seizure.
3. Move at least 3 meters away from the fuel point before starting the engine.
4. Using improper fuel will cause severe damage to the internal parts of the engine in a short time.
Check that all screws are tight and adjust them if necessary.
Filling the oil .
RURIS 4T-MAX lubricating oil .
Place the machine on a flat surface while refueling.
To check the oil level, use the oil dipstick, the oil must be at the maximum level.
Check for oil leaks.
Clean the unit of dust and dirt, especially the air filter.
7.1 Starting
▪
If a machine starts to run abnormally, becomes sluggish, or suddenly stops, stop it immediately. Disconnect the
machine and determine whether the problem is the machine or whether the Power generator's rated load
capacity has been exceeded.
▪ Make sure that the rated load capacity of the tool or appliance does not exceed the Power generator's power.
Never exceed the Power generator's maximum power. Power levels between the rated and maximum value can
be used for a maximum of 30 minutes.
WARNING!
6

6. PRE-OPERATION CHECKS

7. COMMISSIONING