Emission Control System; Maintenance Table - Ruris R-Power Ge9000Rc Ats Handbuch

EN
2. Turn the fuel valve lever to the OFF position.
Starting from the remote control :
Make sure the fuel valve is open, the ignition is in the ON position, then press the 0N button on the remote control
for 1 second, the starting module will be activated, and the Power generator will start according to the
winter/summer control modes.
Remote control shutdown
When the Power generator is running, press the 0FF button on the remote control for 1 second and the Power
generator will stop. After the Power generator has stopped, close the fuel valve and turn the ignition to the OFF
position;
Maximum operating distance of the remote control is approximately 30m. RF signal 433MHZ.

EMISSION CONTROL SYSTEM

Combustion can generate pollutants such as CO, nitrogen oxides, hydrocarbons, which can contaminate the
environment if a large amount of them is emitted into the air. Among these, CO is a colorless, odorless and toxic
gas. It is very important to control them.
Proper maintenance is the owner's responsibility. Refer to the maintenance schedule for specific maintenance.
Please note that this list is based on the general conditions under which the gasoline engine is used. If it is used
continuously under high load or under high temperature with improper humidity or dusty environment,
maintenance should be performed more frequently.
Replacement of spare parts
It is recommended to use only genuine spare parts or their equivalent. Substitution with other, inferior quality
spare parts may adversely affect the performance of the emission control system.
Unauthorized modifications
Unauthorized modifications or changes to the emission control system can cause emissions to exceed legal
specifications. Unauthorized modifications or changes include:
1) Removing or changing any spare part in the intake or exhaust system.
2) Modifying or removing connections for the speed control system that causes the gasoline engine to operate
beyond parameter settings.
The emission may be negatively affected if:
1) Black smoke is emitted or fuel consumption is high;
2) During engine operation, misfires occur in the carburetor or muffler;
3) Ignition occurs earlier or later than normal.
Periodic inspection and adjustment can maintain good performance of the gasoline engine and extend its service
life. The maintenance intervals and items are
presented in the following table:

MAINTENANCE TABLE

8
8. MAINTENANCE