Ruris R-Power GE9000RC ATS Handbuch Seite 22

EN
▪
If the gasoline Power generator needs to be connected to the household power supply, only electrical
technicians should make the connection. Any improper connection may result in a fire hazard or damage to the
gasoline Power generator while the Power generator is connected to the equipment.
▪
The overload protector will be automatically tripped when the circuit is overloaded.
Always take the following steps to keep your Power generator in good condition.
1. Always connect the Power generator with grounding to prevent any kind of danger.
2. If the Power generator needs to provide electrical power for the above loads, be sure to connect them to the
power source.
Manual Power generator start:
1. Turn the fuel valve lever to the ON position.
2. The shock will be operated automatically.
Careful!
Manual starting must be done with the battery connected. For the
shock to be activated automatically, the Power generator battery
must be charged.
3. Turn the ignition to the ON position.
4. Pull the starter handle smoothly until resistance is felt, then pull steadily. Do not allow the starter handle to
suddenly return to the engine. Return gently to prevent damage to the handle or housing. For automatic starting,
turn the ignition key to the START position, then release it.
Careful!
If the Power generator is not used regularly, be sure to turn on the Power generator and Use for at least 2 hours
every 30 days. This will keep the battery charged.
7.2 Stopping the Power generator
1. Turn the ignition to the OFF position.
7
.