Cvc 3000 / Dcp 3000 - vacuubrand MZ 2C NT VARIO Instandsetzungsanleitung

Seite 17 von 40

CVC 3000 / DCP 3000

Replacing the front part with LCD and the pcb
Separate device from mains.
Pull off selection knob.
Unscrew the four Torx screws at the rear side of the device.
Disassemble the two housing parts carefully.
Disassemble ribbon cable from the pcb.
Unscrew the two nuts beneath the interface.
Position the new pcb in the housing rear part.
Screw in the nuts beneath the interface.
Assemble the ribbon cable of the new front part with LCD on the pcb. Comply with correct position of
the ribbon cable.
Assemble the two housing parts and screw in Torx screws.
Assemble selection knob.
Das Dokument darf nur vollständig und unverändert verwendet und weitergegeben werden. Es liegt in der Verantwortung des
Anwenders, die Gültigkeit dieses Dokumentes bezüglich seines Produktes sicher zu stellen. 999211 // 19/03/2013
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. 999211 // 19/03/2013