Rotel RP-2500 Bedienungsanleitung Seite 11

EXCLUSIVE NOTE FOR U.K.
If your unit comes with a 3-core
without a plug, make certain
and (where appropriate) earth
connected to the proper terminals.
that the terminals are screwed down firmly
and no loose strands of wire are present.
WARNING: THIS APPARATUS
BE EARTHED
IMPORTANT: The wires in this
are coloured in accordance with
ing code:
GREEN/YELLOW:
EARTH
BLUE:
NEUTRAL
BROWN:
LIVE
As the colours of the wires in the mains lead
of this apparatus may not correspond with
the coloured markings identifying the ter-
minals in your plug proceed as follows.
The wire which is coloured
YELLOW must be connected to the ter-
minal in the plug which is marked by the
letter E or by the safety earth symbol
or coloured GREEN or GREEN/YELLOW.
The wire which is coloured BLUE must be
Gonnected to the terminal which
with the letter N or coloured
BLACK. The wire which
BROWN must be connected to the terminal
which is marked with the letter
coloured BROWN or RED. The apparatus
must be protected by a 3 Amp fuse if a 13
Amp (BS1363)plugis used.If anothertype
of plug is used a 5 Amp fuse or lower must
be used, either in the plug or adapter or at
the distribution board.
SPECIFICATIONS
MOTOR
cable
live, neutral
leads are
Check
MUST
mains lead
the follow-
TONEARM
GREEN/
,
is marked
BLUE or
MISCELLANEOUS
is coloured
L or
Note: Specifications subjectto change for improvement w ithout
11
AND TURNTABLE
MOTOR
DRIVE
SPEEDS
SPEED CONTROL CHANGE
WOW AND FLUTTER .
SIGNAL-TO-NOISE RATIO.
PLATTER
TYPE .
OVERHANG
TRACKING ERROR
SUITABLE CARTRIDGE
WEIGHT
SUITABLE STYLUS
PRESSURE
POWER REQUIREMENT
POWER CONSUMPTION
OVERALL DIMENSIONS
NET WEIGHT
prior notice.
Frequency-generator DC
motor
Belt-drive system
33-1/3 and 45 rprn, electronically
changeable
.
±5%, individually adjustable
each speed
Less than 0.05% WRMS
.
Better than 58 db
Full-size aluminum alloy die-cast
platter (310 mm) with embossed
strobe markings on rim
Static-balanced S-shapedpipe arm,
with plug-in headshell, oil-damped
cueing device, direct-readout stylus
gauge counter weight, anti-skating
device
1 1 mm
. +3.50
minimum 4 g & maximum 14 g
minimum 1.5 g maximum 3 g
100/120V, 50/60Hz, or
220/240V, 50/60Hz
(depending on destination)
maximum 10 watts
436mrn (W) x 345mm (D) x 145
mm (H)
6.5 kg/14.3 lbs.
servo
for