Connection With The Mains; Operation; Stand Alone Operation; Master/Slave Operation - EuroLite tmh xb-200 Bedienungsanleitung

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
The device is equipped with a lockable power input connector. Plug in the power cord and turn it to the right
until it locks. Plug the power cord into a grounded electrical outlet that matches the rated voltage of the
machine.

OPERATION

With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the TMH XB-200 starts running. During the reset, the motors are
trimmed and the device is ready for use afterwards.
Stand-alone operation
In the stand-alone mode, the TMH XB-200 can be used without controller. Disconnect the TMH XB-200 from
the controller and call the internal program. Please refer to the instructions under Control Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave-devices, which are to be connected to the master device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Set the desired master mode – "Auto run" or "Sound run" - for the master device, as described in chapter
Control Board. Set the DMX address 001 for all slave devices.
International
L
N
31/40 00096412.DOCX, Version 1.0