Herunterladen Diese Seite drucken

Gude DHH 1100/20 TZ Originalbetriebsanleitung Seite 12

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Keep the handles dry, clean and with no oil and grease.
Unplug the electrical appliance if not used and before
maintenance or adjusting.
Check whether keys and adjusting tools have been
removed before switching the appliance on.
Prevent unintentional starting. Make sure the switch is off
when plugging the appliance.
Only approved and appropriately marked extension
cables to be used outdoors.
Pay attention to what you are doing. Use common sense
when working. Do not use the electrical appliance if you
are not concentrated.
Faultless and specified working of the protective
equipment or slightly damaged parts need to be checked
carefully or replaced before electrical tools are used the
next time.
All parts on the appliance must be regularly checked for
signs of damage or aging. The appliance must not be
used if not in a perfect condition.
Do not use electrical appliances where the switch cannot
be switched on and off.
Only original spare parts to be used for repairs.
Repairs may only be performed by an electrician.
Check the appliance for any signs of wear or damage
before putting the appliance into operation and after any
impact and have necessary repairs performed.
Never use spare parts or accessories not approved or
recommended by the manufacturer.
Make sure other items do not cause short circuit on the
appliance contacts.
The appliance is no children's toy! Children are unable
to estimate the risk related to this appliance. Do not let
children use the appliance in any case.
Persons that are unable due to their physical,
sensory or mental abilities or inexperience to operate
the appliance must not use the appliance.
If the appliance has any visible damage, it must not
be put into operation.
Unauthorised repairs may result in considerable
risks.
Identical regulations apply for accessories.
Güde GmbH & Co. KG does not guarantee for the
following damages:
Damage on the appliance as a result of mechanical
influences and overvoltage.
Changes on the appliance.
Use for any other purposes than those described in
the manual.
All safety instructions must necessarily be followed
to prevent injuries and damage.
Appliance-specific important safety instructions
Keep the place of your work clean at all times and
remove any wood remains fallen down.
Keep in mind that wood is a natural raw material and may
get out of control when being split (unexpectedly thrown-
off wood pieces)
Safety shoes should always be worn.
Keep your hands outside the wood face or splitting knife
entry at all times.
Faces of the split wood must be rectangular if possible so
that wood stays safely on the supporting table and cannot
slip to the side.
Safety equipment of the appliance must not be
disassembled or put out of operation.
Remove wood, wood waste and bark from the place of
appliance operation.
Check the feeder cables. Do not use feeder cables that
are faulty.
Check whether the two-handed operation works properly
before putting the appliance into operation.
Wear closefitting clothes. Remove jewels, rings and
wristwatch.
Wear protective clothes.
Attention during work: Risk of injury to fingers and hands
caused by the splitter.
All the protective equipment and covers must be
fitted to the appliance and function faultlessly when
working with the appliance.
Use an appropriate supporting tool for splitting heavy or
big pieces.
Tool change, adjustment, cleaning, maintenance and fault
removal must only be performed when the engine is
switched off. Pull the plug out of socket!
All protective and safe equipment must be refitted
immediately after repair and maintenance are finished.
Put the splitter on a flat and nonslip operating surface
before using it. Ensure sufficient free movement.
Never use the wood splitter when raining.
Line voltage must correspond to the details on the
appliance type label.
Unwind the cable to the full extent when a cable drum is
used to prevent it from heating.
The socket must be fitted with a safety switch against
stray current when working outdoors.
The processed piece of wood must always be put on the
appliance surface in a stable position to prevent it from
moving.
Do not split soaked wood.
Only one piece of wood should always be split.
Do not split wood containing foreign items.
To remove faults or jammed pieces of wood, the
appliance should always be switched off and unplugged.
The jammed piece of wood should not be removed before
switching off and unplugging the appliance.
Behaviour in case of emergency
Provide necessary first aid treatment corresponding to the
injury nature and seek qualified medical help as soon as
possible. Protect the injured person from other injuries and
calm him/her down.
First aid kit must always be available in the place of your
work in case of accident in accordance with DIN 13164.
Material taken out of the first aid kit needs to be
supplemented right away.
If help is needed, please provide the following details:
1.
Place of accident
2.
Accident nature
3.
Number of injured persons
4.
Injury type
Marking:
Product safety:
Product corresponds to
appropriate EU standards
Prohibitions:
General prohibition
Use in closed spaces prohibited!
No pulling the cable!
12
No open fire!
No smoking!
Appliance to be operated by one
person only!

Werbung

loading