Thomashilfen Ronja Reha Bedienungsanleitung Seite 34

4. Installing your child seat (rearward facing) in
IMPORTANT - This child seat has been designed to perform safely and independently of further external restraint.
4a
4b
4c
4d
34
IMPORTANT - Existing passenger airbags MUST ALWAYS be switched-off.
IMPORTANT - The child seat
seat belt.
The child seat has an adjustable support leg
more reclined the seat must be. The larger the child the more upright the seat
must be.
To change the position (if required) pull the support leg clips off of either side
and slide the telescopic leg in or out
of the support leg, refit the clips in the holes (inset). Make sure the hole
positions chosen are the same on both sides.
Push the vehicle front seat back to accommodate the child seat ensuring that
any passenger directly behind will still be able to sit in a comfortable position.
The larger your child, the more upright the sitting position should be.
Place the child seat rearward facing and push firmly into the car seat
IMPORTANT - DO NOT
close to the windscreen.
Extend the footprop fully and make sure that the footprop tether brackets are
facing forwards and that the straps are not twisted. Lower the footprop and
adjust the height so that it is within approximately 30mm of the floor
(dia 4c). Use the ruler printed on the back page of this manual to get the
correct distance from the footprop to the floor.
4e
3
4
front seat
MUST only be used with a lap and diagonal
(dia
(dia 4b). Once satisfied with the position
rest the back of the child seat on the dashboard or
Slide the loop ends of the tether straps
between the front car seat and back
as shown
ends of the tether straps around the
outside of the car seat and feed through
the loops
under the seat. Snap the buckles of the
tether straps onto the tongues on the
sides of the child seat
tighten the tether straps by pulling the
2
loose ends downwards
4a). The smaller the child the
(dia
(dia 4d). Bring the buckle
2 . Slide the buckle ends
3 . Provisionally
4 .
4c).